Re: Come Cross Test Circuit Theory in Simulation, Over Unity Circuit



On Mon, 11 Feb 2008 04:24:11 -0800 (PST), The Flavored Coffee Guy
<elgersmad@xxxxxxxx> wrote:

How it works is a long lecture and discussion in detail. Since, I've
already started the discussion on another BBS and will not keep any
secrets or hide any schematics, I'm callenging all of you and the
pros. This over Unity Device Really will work. Join the discussion.

http://boards.startrek.com/community/messages.html?s=bb7cc215d317e9e36f2cda1ec5297c8b;act=ST;f=10;t=33309396

I suggest you learn about power factor. Try find "A Course in
Electrical Engineering, Volume II, Alternating Currents"; Dawes,
Chester; McGraw-Hill; 1947. It has chapters of wonderful information
that modern books don't cover about power factor and how to measure
power.

Hey Jim T., did you know Arthur Casey or Jordan Miller back in MIT? My
copy of the above book was used by them back in the late 1950s. Book
was only $4.90 (used) back then.

---
Mark
.



Relevant Pages

  • Re: Come Cross Test Circuit Theory in Simulation, Over Unity Circuit
    ... secrets or hide any schematics, I'm callenging all of you and the ... pros. ... This over Unity Device Really will work. ...
    (sci.electronics.cad)
  • Re: Yet unadressed topic : cathode follower before the tone stack
    ... not to its full extent though and it's a pain in the ass to transfer the schematics to the program. ... From my previous experience of building a tube power amp, I stuck to the schematics and it works perfectly so I think that sticking to the schematics will give something at the very least workable. ...
    (alt.guitar.amps)
  • Re: Yet unadressed topic : cathode follower before the tone stack
    ... to transfer the schematics to the program. ... From my previous experience of building a tube power amp, ... I took a 4*6L6GC power amp section and simply put 2*EL84 instead ...
    (alt.guitar.amps)
  • Re: Silly resistor values
    ... Power supplies normally get connected on globals. ... Power supplies make a mess of schematics and add little ... have multiple blocks because there are dozens of channels but delay ... hardware engineers, three firmware types, a layout engineer, ...
    (sci.electronics.design)
  • Re: Yet unadressed topic : cathode follower before the tone stack
    ... to transfer the schematics to the program. ... I took a 4*6L6GC power amp section and simply put 2*EL84 instead ... Yeah yeah, I know, PCB has a bad reputation for tube amps but once again, my ...
    (alt.guitar.amps)