Re: Protel 99SE netlist issue


"Dennis" <dennis@xxxxxxxxxxx> wrote in message
news:4a307632$0$32351$5a62ac22@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
I have a file project.prj with three associated schematics schem1.swch,
shem2.sch......

When I create the netlist the third *** is not included. The netlist
also seems to be ignoring some parts on one of the other sheets.


The design explorer on the left shows all three sheets as being in the
hierarchy for the project. When I go <file> <open full project> all the
required 3 sheets open as expected.




I have ports & net labels set to global etc.

Anyone have any ideas what I'm doing wrong?

thanks
Dennis


It gets worse.

I can create a new design, fresh single *** schematic, add a few parts,
annotates ok. When I netlist the netlist is completely empty. When I check
the servers the netlist server shows up as loaded & started. IF I load up an
old design the netlist seems to run fine.

SP6 is installed & I just reinstalled both 99SE & SP6 and still have the
same problem.

Aaaaaaagh!! Its not April 1st or Fri 13th so WTF am I missing?


.

Loading