Need help identifying resistor

I need to replace a resistor and can't seem to figure out the value. The
body color is gray and the bands are green, blue, gold, gold, white. I
googled for precision resistor color codes, but had no luck. Any ideas?
.

Relevant Pages

  • Re: Help needed identifying failed components
    ... Probably Red, Black, Gold, Black, Brown. ... The fourth band might have been printed by a machine ready for the 4-colour scheme for value, but set to put the unused black band for the old three colour scheme after the multiplier instead of before it as is usual on metal film types in readiness of an extra significant digit. ... I have to assume, that its value is most likely 1 Ohm at most, perhaps even 0.1 Ohm,. ... From a tap of the SMPS transformer, a HER303 diode, which shorted out is connected via a wire bridge with a ferrite core around it to this little 7mm × 2mm fusible resistor, and from there feeding the CRT cathode heaters with a negative 6.3V voltage. ...
    (sci.electronics.components)
  • Re: Resistor value & visible condition?
    ... Plus, does the body color ... > gray give me any additional information about the resistor? ... wirewound, non-flammable type, at least 1W. ...
    (sci.electronics.repair)
  • Re: Testing resistors and GND? Meteor MPU 200 continued.
    ... brown, brown, orange, gold 11kohms (bob roberts page) ... resistor, my tester will give the "buzz" sound? ... R25 and R26 are dead on 20 ohms. ...
    (rec.games.pinball)
  • Re: Damaged resistor - what happens?
    ... If black, brown, black, gold was the original color code--well, it's a ... sub-10-ohm resistors should have a gold or silver third band, ... My suspicion is that it _might_ be a flameproof resistor as you say, ... They will survive a long time at five watts ...
    (rec.radio.amateur.homebrew)
  • Re: EOLs
    ... It's too bad you didn't keep the resistor. ... Manufacturers use the tolerance color band to tell ... a resistor with three red bands and one gold ...
    (alt.security.alarms)