<angdis-bb@xxxxxxxxx> wrote in message
news:1124904565.729864.280460@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx > Hi,
>
> I have a hirose connector (a type HR10A plug with soldering cups).
>
> One of this series...
> http://www.hirose-connectors.com/products/HR10_5.htm >
> I would very much like to solder a cable to this damn thing, but I
> can't figure out how to get access to the solder cups!
>
> I give up, what is the trick? Obviously, I somehow have to force the
> assembly that contains the pins out of the connector body so that I
> can solder to it. But it seems that it won't budge.
>
> Anyone have experience with these?
>
> Thanks!
> -A.
Many connectors require a special insertion/extraction tool to remove
the pins. But I've only seen these with crimp-on pins, never with
solder types[1]. Maybe Hirose has a solution. Contact them.
[1] After doing hundreds of DB connectors back when RS-232 was the
mainstay of datacomm, I changed from solder to crimp-on connectors. I
went from what seemed an eternity to solder a connector to just a few
minutes. You might heed that advice from an old firm believer in
solder, crimp-on _is_ a drastic time saver. The good quality tools
aren't cheap but they pay for themselves many times over.
Re: MCX connector repair (in UK) (only vaguely on topic I admit) ... I've accumulated several crimping handles and a number of the die sets over the years purchased at retail). ... you can see the approx O.D. of the various coax sizes.... Sliding the connector on can create a slightly expanded section where the connector slides down between the dielectic and the braid and the sheath. ... The process is to cut and trim the coax to the lengths shown and tin the exposed tip of the center conductor with a little solder.... (sci.geo.satellite-nav)
Re: LH series ATC display. Was: 02 300M: Code P0700 and... ... the LH cars.... I would think that woujld be covered under the extended warrranty too - hopefully it will decide to act up when they're looking at it - perhaps a gentle banging with the fist will cause it to act up. ... The connector has a tab on one side that you push in to release and de-mate the connector from the control unit. ... Also - you may not even be able to see the cracks in the solder.... (rec.autos.makers.chrysler)
Re: Hand reworking SMT mictors? ... thickness of the stencil means the connector won't seat properly. ... with a small screwdriver and solder the pin by hand then mash the ...Heat the board gently with a paint stripper to remove ... clean the pads using desoldering braid. ... (sci.electronics.design)
Re: Repair log: What did YOU fix today? ... Replaced the corresponding digit 2 pin in connector A1J3 at the ... with the lights...solder to the wires on the leaf blades, ... and took the two leaf blades out. ... (rec.games.pinball)
Re: 240D lights problem ... I'll try to eliminate everthing down to the ignition sw. ... I did find a loose brown wire with a 1/4" wide spade connector but I don't see any matching spade connector. ... Four wires are connected to the box via large blobs of solder and the 5th wire is free but it has a blob of solder on the end and I can't see where it might have broken off from any of the solder blobs. ... (alt.auto.mercedes)
