Diff-Amp

Hello,
i am searching for an Diff-OPAmp.
I´ve got two signals between 0 and 1 V, Audio frequencies.
A possible supply voltage of 0-5 V and very few available space.
Does anyone have some suggestions what component would be good to use?

Thank you and best regards
Roland Schlierf


.

Relevant Pages

  • Re: USB O-Scope recommendations?
    ... Jay Ts wrote: ... They are limited to audio frequencies, and cannot do DC measurements or ... see signals into MHz frequencies, but when used with a decent sound ... have any opinion whether this is sufficient? ...
    (rec.audio.pro)
  • Re: USB O-Scope recommendations?
    ... They are limited to audio frequencies, and cannot do DC measurements or ... You _will_ need to see signals into the MHz region.... ... for DC offsets in the signal, low-frequency bias oscillations, ... have any opinion whether this is sufficient? ...
    (rec.audio.pro)
  • Slight digression Re: Power-On Reset
    ... Many FPGA and CPLD circuits do not become sane until the supply voltage ... reset chips also could be used to force the SELF-DESTRUCT signal to ground ... and then glitch free connect them to the signals from the CPLD. ...
    (sci.electronics.design)
  • Slight digression Re: Power-On Reset
    ... Many FPGA and CPLD circuits do not become sane until the supply voltage ... reset chips also could be used to force the SELF-DESTRUCT signal to ground ... and then glitch free connect them to the signals from the CPLD. ...
    (sci.electronics.cad)
  • Re: Is it possible to simulate ac signal with dc?..tia sal
    ... Audio frequencies are AC. ... > I was wondering if I offset/change the phase of the signals in a certain ... > TYPE signal using my sound card if possible...trying to keep it cheap. ...
    (sci.electronics.misc)