Re: Where to get thermistors in the UK?



Sorry I can't help source the thermistor you require. I'm looking to do
the same as you - make a replacement renault outside temp. sensor.
Assuming it was possible to find the required thermistor, do you have
any thoughts on the resistor(s) needed to correct it?

David

Howard wrote:

I'm looking for an outside temperature sender replacement for a renault
laguna. (£70 in the spares shop!)

I understand that I can make one with a 2.7K @ 25 deg beta 3877 thermistor
such as the Vishay 2322 640 55272 plus a couple of resistors to corect it.

Unfortunately the only place I can find (Farnells) sells them at £1.32 each
but with a minimum order of £20. Other places want me to buy 750 of them at
once. - I only want one (or two so that I have a spare for next time)

Anyone know where such a thing can be bought over the net in singles or
where there is a shop near to Huntingdon in Cambridgeshire, UK?

Howard

.



Relevant Pages

  • Re: Sensing humans around the robot - what sensor?
    ... I've thought about using a thermistor mounted ... Infrared thermocouples allow for fairly accurate temperature non-contact ... If you could scan the sensor you could make a little map and determine ... I have not found infrared thermocouples for under $10. ...
    (comp.robotics.misc)
  • Re: Driver circuit. How do you figure out what transistor and resistor values to use? Need help
    ... > buzzer when the liquid reaches that certain level in the mug. ... > sensor, or thermistor, which will sound the buzzer (I think it's ... it will source enough current into the base of the NPN transistor ... I can say that sensing temp with a thermistor will require an EXACT ...
    (sci.electronics.basics)
  • Re: Thermistor for a Shure Vocal Master?
    ... >>but one came into the shop this week which isn't TOO ugly. ... >>The Vocal Master used a PTC thermistor in series with the AC primary. ... >>overload" light shines. ... >>little voltage, natch), and perhaps 5A when it's low resistance. ...
    (alt.guitar.amps)
  • Re: Driver circuit. How do you figure out what transistor and resistor values to use? Need help
    ... >> buzzer when the liquid reaches that certain level in the mug. ... >> sensor, or thermistor, which will sound the buzzer (I think it's ... And lastly, a tilt sensor, which will either 1. ... > I can say that sensing temp with a thermistor will require an EXACT ...
    (sci.electronics.basics)
  • Re: Thermistor for a Shure Vocal Master?
    ... >but one came into the shop this week which isn't TOO ugly. ... >The Vocal Master used a PTC thermistor in series with the AC primary. ... >little voltage, natch), and perhaps 5A when it's low resistance. ... >the normal line fuse), ...
    (alt.guitar.amps)

Loading