Re: help on LM2576 with minus (-12v)
- From: Jamie <jamie_ka1lpa_not_valid_after_ka1lpa_@xxxxxxxxxxx>
- Date: Sun, 14 May 2006 10:19:10 -0700
xuzhenxz@xxxxxxxxx wrote:
help needed.did you make a mistake and not insulate the
i use the exact circuit (figure 10) in the manual of LM2576, but cant
get the output of -12v
the power supply is 24v with the max amp of 5amp, when it turns on the
chip get hot and the power supply get overloade with a high amp of
about 3.5amp.
is there any one can help on this? THanks.
back side of the chip from the ground ?
as you are using the ground here as the - output
the back plane of the chip is usually connected to
the ground also.
so in turn, you are dead shorting the chip if this
is what your doing.
--
Real Programmers Do things like this.
http://webpages.charter.net/jamie_5
.
- References:
- help on LM2576 with minus (-12v)
- From: xuzhenxz
- help on LM2576 with minus (-12v)
- Prev by Date: Re: Z8 chips with Tiny Basic
- Next by Date: Re: Spammers aren't always male
- Previous by thread: Re: help on LM2576 with minus (-12v)
- Index(es):
Relevant Pages
|
