Re: disable cold junction compensation
<ian_journeaux@xxxxxxxxxxx> wrote in message
news:1161039387.899062.104130@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
I was wondering if anyone might know how to disable the cold junction
reference on a Watlow 93 temperature controller.
I would like to use the controller to control the differential
temperature in a heating system.
You want to measure temperature rise over something? What are the two
sensors connected to?
.
Relevant Pages
- Re: Desk Top Furnace
... It?s temperature is controlled by a 3 position switch. ... I would like to better control the heat in this furnace to allow ... As Jim mentioned in his reply a temperature controller, ... The 9500P is destined for a glass melting furnace and the 3200 is likely ...
(rec.crafts.metalworking) - Re: Desk Top Furnace
... It’s temperature is controlled by a 3 position switch. ... I would like to better control the heat in this furnace to allow ... As Jim mentioned in his reply a temperature controller, typically with PID, capable of SSR drive, and a thermocouple would be a good choice. ... The 9500P is destined for a glass melting furnace and the 3200 is likely to end up in my little desktop furnace as it's 1/32 DIN IIRC. ...
(rec.crafts.metalworking) - Tuning PID controllers for use in espresso machines (very long)
... The Fuji controller can be tuned using the autotune method ... Usually espresso machines possess powerful heaters that allow them to ... quickly recover temperature when brewing or steaming takes place. ... One parameter sets a maximum setpoint ...
(alt.coffee) - Re: Desk Top Furnace
... It?s temperature is controlled by a 3 position ... I would like to better control the heat in this furnace to allow ... As Jim mentioned in his reply a temperature controller, ... The 9500P is destined for a glass melting furnace and the 3200 ...
(rec.crafts.metalworking) - Re: Desk Top Furnace
... It’s temperature is controlled by a 3 position switch. ... As Jim mentioned in his reply a temperature controller, typically with PID, capable of SSR drive, and a thermocouple would be a good choice. ... The 9500P is destined for a glass melting furnace and the 3200 is likely to end up in my little desktop furnace as it's 1/32 DIN IIRC. ...
(rec.crafts.metalworking) |
|
