Re: looking for power transformer - no search results


Can you not wire it up and see what voltages it outputs?

Unfortunately, the jolt not only broke the plastic mounting frame, but
it also ripped the wires right out of the pins. It's a mess :-)

It's an older piece of gear, but a good one. I'm trying to see if
there is a quick fix (buy/replace xformer) rather than a long journey
through OEM schematic, parts list, etc. Purely economics. X hours of
my time taken up = just pitch it and buy a new one.

Thanks to all who replied.

.

Relevant Pages

  • Re: looking for power transformer - no search results
    ... Unfortunately, the jolt not only broke the plastic mounting frame, but ... it also ripped the wires right out of the pins. ... It's a mess :-) ...
    (sci.electronics.components)
  • Re: Soldering bypass caps to QFP possible?
    ... and that's also where the lone bypass cap dwelleth. ... Something I've done in the past is to make cover the top of the chip in solid copper foil tape, soldering the outer tape edges to all the ground pins you have available (using 30 ga. ... The wires would be a royal pain in the neck though. ...
    (sci.electronics.design)
  • Re: Soldering bypass caps to QFP possible?
    ... and that's also where the lone bypass cap dwelleth. ... the power pins. ... Make a tiny PCB that has bypass caps, and glue it on top of the chip, ... and drop down ground and vcc wires. ...
    (sci.electronics.design)
  • Stern Meteor - Resurection, whats the smell?
    ... Bringing this one back to life, the guy got a couple of games cheap ... The pins were stored ... flipper plates broken, never saw this before, good thing I kept some. ... shrink bad wires behind board, replace J1 back ...
    (rec.games.pinball)
  • Re: Soldering bypass caps to QFP possible?
    ... cost and risk management. ... then conformally coat again to glob the wires and cap down. ... How many pins are there for the existing QFP? ... Possibly my client might take you up on that :-) ...
    (sci.electronics.design)