Re: LM393 driving small MOSFET



ian field wrote:

"Eeyore" <rabbitsfriendsandrelations@xxxxxxxxxxx> wrote in message

You might be better off with an op-amp then.

Graham

Already looked at OP-AMPs - with the low Vcc headroom none of the devices I
looked at could guarantee close enough to true "rail to rail" O/P.

What supply voltage is available ?

Graham


.

Relevant Pages

  • Re: Need OP-AMP for operation of input close to ground
    ... interface the temp sensor to A/D converters on a micro-computer, ... amplify the temp sensor signal by a Gain of 3.3 in order to get a 0V to ... My problem is that when I used a 741 op-amp I didn't get ... yes you need an op amp that is classed as rail to rail output and either ...
    (sci.electronics.design)
  • Re: LM393 driving small MOSFET
    ... ian field wrote: ... You might be better off with an op-amp then. ... Already looked at OP-AMPs - with the low Vcc headroom none of the devices ... looked at could guarantee close enough to true "rail to rail" O/P. ...
    (sci.electronics.components)
  • Re: What does Rail Mean ?
    ... LM741 does not have Rail output, this means that a 741 can not have ... it's output reach the Vcc+ (Supply voltage). ... would need an op-amp that could reach the rails of the supply voltages. ...
    (sci.electronics.basics)
  • Re: LM393 driving small MOSFET
    ... ian field wrote: ... You might be better off with an op-amp then. ... Already looked at OP-AMPs - with the low Vcc headroom none of the devices ... looked at could guarantee close enough to true "rail to rail" O/P. ...
    (sci.electronics.components)
  • Re: Voltage offset
    ... If you use a 5V rail as your offset source you could ... Pardon me, but I don't understand the term "rail", do you mean my ... op-amp is *expensive* compare ... to the above circuit, but if a running after trouble with this design, ...
    (sci.electronics.design)