Reusable Electrical Connector between Electronics Package and Flexible Sensor Substrate

Dear all,

I was wondering if any of you knows about commercial connectivity
solutions that enables to make an electric connection between an
electronics package and a flexprint. The requirements are:
- mechanical robust and stable
- solderless and glueless
- electronics should be reusable, i.e. the connector can be opened and
closed many times
- 2 electrical contact are needed
- not bulky

I was personally thinking about some conductive velcro or a clamp that
punches some pins through the flexible substrate film.

Any kind of suggestions, links, etc. are welcome!

Thx,
David

.

Relevant Pages

  • Re: ? Overloaded Auto Chromatic Tuner
    ... I'm lucky repair it (I assume it's a dead component that needs to be ... While I am no electronics expert, I am also not a novice. ... or a quick connectivity test reveals nothing ... and knocked out the 78L05 as no reverse protection. ...
    (sci.electronics.repair)
  • Reusable Electrical Connector between Electronics Package and Flexible Sensor Substrate
    ... I was wondering if any of you knows about commercial connectivity ... electronics package and a flexprint. ...
    (sci.electronics.misc)
  • Re: wave propagation in resistive media
    ... you've got a high-power broadband noise source. ... are at the part of the EM spectrum your electronics care about. ... As Timo says doubling layers halves ... you'll pretty much have to wrap the whole electronics package in the ...
    (sci.physics)
  • Re: wave propagation in resistive media
    ... you've got a high-power broadband noise source. ... are at the part of the EM spectrum your electronics care about. ... As Timo says doubling layers halves the signal. ... the whole electronics package in the stuff. ...
    (sci.physics)