Little help with 100k lin pot. Please?



Ok, Thanks for reading my post.

I have a Taylor 68 A/M RF and AF sig gen (valve) off eBay, cheap.

Low volume on AF and low output RF signal. Tracked it down to the volume pot obviously.
100k lin with 2 pole switch on/off on the back. Gone to 380k with most of the track gone.

The worry I have is, it says nothing about power disipation of the track.
It's a fairly big pot at 40mm dia with a metal back, bakelite front and patent number 439028.
I don't want to put a standard modern one in just to have it go bang on me or cause more damage .

If you have any ideas or a circuit diagram that would help a lot.

Thanks


.



Relevant Pages

  • Re: Deluxe Reverb Clone
    ... after the gain pots, though. ... bypasses the pot at higher frequencies, ... I had a Hiwatt custom 100 in for a valve change ... I need to put a power ...
    (uk.music.guitar)
  • Re: Brew Kettles
    ... cheap to get started, I can always replace it later on. ... The best deals I could find were a 16 quart stainless steel for $19.99 ... I was surprised at the lack of aluminum ... pot before you use it, and when you clean, don't make it shiny again. ...
    (rec.crafts.brewing)
  • Re: My tea kettle just died
    ... I did tinny and cheap and plastic till my brother came ... which has many of the features of your pot. ... > could handle high heat for hours after a boil down. ...
    (rec.food.drink.tea)
  • Re: Good for outdoor brewing?
    ... with my own pot ... regulator and used the tank coupler from an old dead BBQ. ... A small check valve is in this device ... and will close when it senses the flow to be to high.The high flow is ...
    (rec.crafts.brewing)
  • Re: Wah pedal noise
    ... I bought it on Ebay, ... Sometimes a pot will clean itself. ... >> It it's the whooshing sound, you're probably just hearing the sound of ...
    (alt.guitar)