Re: voltage multiplier

From: Mac (foo_at_bar.net)
Date: 01/24/05 

Date: Mon, 24 Jan 2005 00:13:44 GMT

On Thu, 20 Jan 2005 23:11:52 -0800, kumar_prashu wrote:

> hello all
> i want to know about the voltage multiplier chips.
> the ratings should be such that
> voltage output up to 50 voltage
> current output = 1 or 2 amp. or please suggest some circuit
> thanks

Based on the naivete of your query, there is no chance at all of you
successfully building such a circuit. I suggest you seek professional
assistance with your project, and please do not post any more similar
questions to this newsgroup.

--Mac

Relevant Pages

  • Re: Interupting xenon flash current ?
    ... ratings that were necessary to use for designs in impulse circuits. ... enough for the capacitor to drain almost fully and it seems the IGBTS ... the capacitor voltage would not have reduced appreciably. ... the di/dt enough to avoid destruction of the thyristor on turn on. ...
    (sci.electronics.design)
  • Re: Switch Contact Rating Question
    ... Switch ratings have more than one limiting property. ... So the load current and voltage limits depend on both the off state voltage, the load current, whether the current is AC or DC, whether the load is resistive or inductive, how fast the contacts separate, how far the contacts separate, the expected cycle life of the contacts, etc. ... The load current limit here depends on whether the load is inductive or resistive and if resistive, if they are incandescent (low cold resistance produces large inrush current), how many bounce cycles, whether or not the contacts wipe, etc. ...
    (sci.electronics.design)
  • Re: Two ways to fry a component
    ... There are lots of voltage and current ratings for parts. ... maximum voltage permitted on the pin as an input usually). ... electronics, context can be everything. ...
    (sci.electronics.basics)
  • Re: 845 dreams was:Re: Why is Poopie two cheeks short of being an asshole? And hes two slices short
    ... Chris Hornbeck wrote: ... 400 volts at 30mA is within ratings. ... A supply voltage of 800 volts is about right. ...
    (rec.audio.tubes)
  • Re: need info on mystery shallcross component
    ... Hey don,,,most components will have these ratings on them to ... Usually the higher the amperage the bigger the physical size. ... There are instances today where we are using high voltage in smaller ... If you ever pulled a fuse from something that runs on regular 110 v ...
    (sci.electronics.design)