Re: Need a bit of PIC programming
From: Glenn Ashmore (gashmore_at_cox.net)
Date: 03/12/05
- Next message: Winfield Hill: "Re: Searching for engineer experienced in 24V vehicle electrical design."
- Previous message: Ken Smith: "Re: Considerations for Multiplier Design"
- In reply to: Luhan Monat: "Re: Need a bit of PIC programming"
- Next in thread: Mark Jones: "Re: Need a bit of PIC programming"
- Messages sorted by: [ date ] [ thread ]
Date: Fri, 11 Mar 2005 22:28:07 -0500
"Luhan Monat" <x@y.z> wrote in message
news:QEsYd.4159$uk7.2615@fed1read01...
> Next time your boat sails thru Phoenix, drop me a line ;>
'Bout as close as I can get with a 7' draft is Houston. Will that do? :-)
-- Glenn Ashmore I'm building a 45' cutter in strip/composite. Watch my progress (or lack there of) at: http://www.rutuonline.com Shameless Commercial Division: http://www.spade-anchor-us.com
- Next message: Winfield Hill: "Re: Searching for engineer experienced in 24V vehicle electrical design."
- Previous message: Ken Smith: "Re: Considerations for Multiplier Design"
- In reply to: Luhan Monat: "Re: Need a bit of PIC programming"
- Next in thread: Mark Jones: "Re: Need a bit of PIC programming"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|
