Re: Veroboard cutting and veroboard-layouting
From: Terry Pinnell (terrypinDELETE_at_THESEdial.pipex.com)
Date: 03/16/05
- Next message: Larry Brasfield: "Re: amplify 40kHz audio signal using TL082: first two stages are fine, but high noise from the third stage"
- Previous message: Nico Coesel: "Re: Can a Logic Analyzer be used for video capturing"
- In reply to: martin griffith: "Re: Veroboard cutting and veroboard-layouting"
- Next in thread: Roger Lascelles: "Re: Veroboard cutting and veroboard-layouting"
- Reply: Roger Lascelles: "Re: Veroboard cutting and veroboard-layouting"
- Messages sorted by: [ date ] [ thread ]
Date: Wed, 16 Mar 2005 20:54:28 +0000
martin griffith <martingriffithX@Xyahoo.co.uk> wrote:
>On Wed, 16 Mar 2005 08:30:46 GMT, in sci.electronics.design Rikard
>Bosnjakovic <bos@hack.org> wrote:
>
>>Greetings
<snip>
>>1. Is there any layout/routing-application that is able to output
>>layouts for veroboards?
Try VCad Perforated Board Layout Editor from Roger Lascelles
http://www.geocities.com/rogerlasau/VCad.html
It's included in my notes and links to some 60 ECAD programs at
http://www.terrypin.dial.pipex.com/ECADList.html
Terry Pinnell
Hobbyist, West Sussex, UK
- Next message: Larry Brasfield: "Re: amplify 40kHz audio signal using TL082: first two stages are fine, but high noise from the third stage"
- Previous message: Nico Coesel: "Re: Can a Logic Analyzer be used for video capturing"
- In reply to: martin griffith: "Re: Veroboard cutting and veroboard-layouting"
- Next in thread: Roger Lascelles: "Re: Veroboard cutting and veroboard-layouting"
- Reply: Roger Lascelles: "Re: Veroboard cutting and veroboard-layouting"
- Messages sorted by: [ date ] [ thread ]
