Re: Low drop discrete p-mosfet linear regulator
From: Steve Sousa (etsteve_at_yahoo.com)
Date: 03/18/05
- Next message: NSM: "Re: Barber-Colman phonograph motors?"
- Previous message: Larry Brasfield: "Re: amplify 40kHz audio signal using TL082: first two stages are fine, but high noise from the third stage"
- In reply to: Steve Sousa: "Low drop discrete p-mosfet linear regulator"
- Next in thread: Larry Brasfield: "Re: Low drop discrete p-mosfet linear regulator"
- Messages sorted by: [ date ] [ thread ]
Date: Fri, 18 Mar 2005 05:56:11 -0000
Hello:
The faster one posts the more mistakes:
There are to errors in my previous post. First, when the circuit is fed 4.2
volts the mosfet's internal diode will put 3.5V on the output, not good.
In the paragraph below the circuit, where it says: "output is 3.6." should
read "output is 3.3"
-- Steve Sousa
- Next message: NSM: "Re: Barber-Colman phonograph motors?"
- Previous message: Larry Brasfield: "Re: amplify 40kHz audio signal using TL082: first two stages are fine, but high noise from the third stage"
- In reply to: Steve Sousa: "Low drop discrete p-mosfet linear regulator"
- Next in thread: Larry Brasfield: "Re: Low drop discrete p-mosfet linear regulator"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|
