Re: Colloidal silver generator?

John Woodgate wrote:

[...]

> There isn't supposed to be ANY ionic silver in colloidal silver
> solution.

[...]

> Regards, John Woodgate

John, all colloidal silver products produced by electrolysis contain silver
ions. For example, Franks's Mesosilver has an ionic concentration of 3.9ppm.
See his lab report at

http://www.silver-colloids.com/Reports/cpr09/cpr_09.html

Other products, such as Mild Silver Protein (MSP), Silver Acetate, and so on,
are silver compounds and are almost completely ineffective as
antibacterial/antifungal/antiviral agents.

The weak silver ion content is what gives Mesosilver it's rather poor
antibacterial properties. The particles in Mesosilver are inert, as shown in
Steve Quinto's analysis at

http://tinyurl.com/3qb4v

Additional supporting data are at

http://tinyurl.com/47ujf
http://tinyurl.com/3mmq2

A typical 3 nines cs generator may produce between 5uS and 10uS,
well-designed constant current cs generators may reach 15uS to 20uS, Trem
William's SG7 can reach 45uS, and my latest double chamber cs generator just
produced a Hanna PWT reading of 74.8uS

http://escribe.com/health/thesilverlist/m79426.html

The particles produced in these generators is silver hydroxide, which is
insoluble, inert, and has no biological activity. You can get an idea of the
amount of hydroxide by shining a laser pointer through the solution to check
for Tyndall.

The test is quite sensitive in a completely dark room. The amount of
scattering increases with hydroxide content. However, it only shows particles
larger than about 63nm.

The particles do not affect the conductivity of the solution. A Hanna PWT can
be used to determine the ionic content since 1uS = 1ppm.

However, the PWT also responds to contaminants, such as bleach, vinegar,
ammonia, etc. In order to get confidence the Hanna reading is reasonable, you
need to verify how much silver was liberated during the brew. The Faraday
equation tells you this, but it is somewhat cumbersome due to the unit
conversions needed. I simplified the equations as follows:

Hours = (uS * Litres) / (F * I)
I = (uS * Litres) / (F * Hours)
Litres = (F * I * Hours) / uS
uS = (F * I * Hours) / Litres

where

F = 4024
Hours = brew time
I = current in Amperes
Litres = volume of dw
uS = PWT reading (1uS = 1ppm)

In addition, a simple salt test using canning or pickling salt produces a
pale blue dispersion of silver chloride at 5uS or so. The dispersion turns
whiter as the ion concentration increases.

Does this help?

Mike Monett
.

Relevant Pages

  • Re: Colloidal silver generator?
    ... > I read in sci.electronics.design that Mike Monett wrote ... >>John Woodgate wrote: ... >>> There isn't supposed to be ANY ionic silver in colloidal silver ... Silver ions are released at the anode when an atom ...
    (sci.electronics.design)
  • COLLOIDAL SILVER MAY HELP YOUR LYME SYMPTOMS
    ... High dosages of colloidal silver over an extended period of time are not ... An antibiotic kills perhaps a half-dozen different disease ... Report on Colloidal Silver, The Best Kept Secret, by Martha Duncan. ...
    (sci.med.diseases.lyme)
  • Re: Time to admit silver works folks.
    ... >>ABUSE REPORT SENT YOU SILVER FRAUD. ... DEPARTMENT OF HEALTH AND HUMAN SERVICESFood and Drug Administration ... Over-the-Counter Drug Products Containing Colloidal Silver ... establishing that all over-the-counter (OTC) drug products containing ...
    (sci.med.diseases.lyme)
  • Colloidal Silver: Risk WITHOUT BENEFIT
    ... Don't listen to the LIARS and silver cult profiteers like BRENT THE ... Colloidal Silver: Risk without Benefit ... hemorrhoids, enlarged prostate, and many other diseases and conditions. ... "Operation Cure.All" wages new battle in ongoing war against Internet ...
    (sci.med.diseases.lyme)
  • Re: Dr Jones IS a living SAINT!!!!
    ... Colloidal silver preparations are marketed on the internet ... Argyria following the use of dietary supplements containing colloidal ... Silver products for medical indications: ...
    (sci.med.diseases.lyme)