Re: mic preamp modification

I read in sci.electronics.design that rex <notat@xxxxxxxxxxxxxxx> wrote (in <i5qd51dstese4da78r80l933v66id016vg@xxxxxxx>) about 'mic preamp modification', on Fri, 8 Apr 2005:
These are not smd parts. They are radial lead, about 5mm dia x 10 mm long. It was hard to read them in the circuit but I didn't see anything other than the 0402 that could be a value, so I assume it might mean 4000 somethings. 

0402 is almost certainly a date code for April 2002.
--
Regards, John Woodgate, OOO - Own Opinions Only.
There are two sides to every question, except
'What is a Moebius strip?'
http://www.jmwa.demon.co.uk Also see http://www.isce.org.uk
.

Relevant Pages

  • Re: mic preamp modification
    ... I read in sci.electronics.design that rex wrote about 'mic preamp modification', on Sat, 9 Apr 2005: ... Regards, Joerg ...
    (sci.electronics.design)
  • Re: mic preamp modification
    ... I read in sci.electronics.design that rex wrote about 'mic preamp modification', on Sun, 10 Apr 2005: ... I looked at your drawings and I think the design would be improved in terms of signal-to-noise ratio with a long-tailed pair of very low-noise discrete transistors before the op-amp. ...
    (sci.electronics.design)