Re: Amp output Z
Hello John,
I believe Harry wants to verify the output impedance of the amp.
Considering that it's in the 10ohm range and the load is a few hundred
the required accuracy is a bit of a stretch for the AC circuitry of many
DVMs.
Regards, Joerg
http://www.analogconsultants.com
.
Relevant Pages
- Ultralinear equations for =?iso-8859-1?Q?=B5?=, Ra, gain.
... I recently cobbled together an integrated stereo amp with ultralinear ... sound) but still gives up to 80% of the pentode PO at low load values. ... Low anode voltages below 20Vrms were used to ... A1 is the voltage gain for RL1, ...
(rec.audio.tubes) - Re: No Interconnect is the Best, attenuation and source switch options.
... sonically obvious except that both lead to very good sound ... Well yes you could always say the amp with an exotic and perhaps ... Load mismatches are the very worst evil in so many amps I have had to ... constant current density manner with a section of either 4 ohms or 6.6 ...
(rec.audio.tubes) - Re: 845 use in SET amps, output tranny info.
... >> Getting a decent square wave with any tube amp isn't always easy ... The ideal core shape for SE amps would be to have a window that is larger than ... The load seen by the tubes becomes -3dB down and partially reactive ... >> Your pentode may or may not produce much 2H. ...
(rec.audio.tubes) - Re: OPT equalising circuit
... What I said about providing a resistance load in PP amps is also valid ... The Zobel is to ensure the tube has a load at HF even though the tube ... of the amp including the OPT winding resistance so that the ... The vast majority of tube amps have no need of such a compensation ...
(rec.audio.tubes) - Re: OPT equalising circuit
... What I said about providing a resistance load in PP amps is also valid ... The Zobel is to ensure the tube has a load at HF even though the tube ... of the amp including the OPT winding resistance so that the ... The vast majority of tube amps have no need of such a compensation ...
(rec.audio.tubes) |
|
