Re: EMC advice - MSP430 design - 4 layer Vs 2 layer

"Martin Riddle" <martinriddle@xxxxxxxxxxx> wrote:

>Unless you want to futz with getting a 2 layer board to work, go for the 4 layer board.
>The real problem in the slew on the clock edges, not the clock speed.
>If your carefull you can get a 2 layer board to be compliant, but its work. Cost factor analysis time.

I doubt clock edges are a problem in MSP430 designs. The outputs have
a very low output current. Perhaps TI has an application note on this
topic.

--
Reply to nico@nctdevpuntnl (punt=.)
Bedrijven en winkels vindt U op www.adresboekje.nl
.