Re: Need a little part ID help.
- From: "Glenn Ashmore" <gashmore@xxxxxxx>
- Date: Thu, 5 May 2005 15:08:55 -0400
> Hi, Glenn:-
>
> Sounds like they could be ceramic diodes, but the circuit doesn't make
> a lot of sense. How old is this device? Where was it made? Can you
> post a link to a photo closeup of the device and the board?
>
>
> Best regards,
> Spehro Pefhany
Here is a link to some pictures.
http://client.webshots.com/photo/339027970/339027970jhNVND
Community Webshots is the quickest way I have found to post pictures without
tackying up the usnet. There are 3 pictures. Click Next & Prev to se the
others.
--
Glenn Ashmore
I'm building a 45' cutter in strip/composite. Watch my progress (or lack
there of) at: http://www.rutuonline.com
Shameless Commercial Division: http://www.spade-anchor-us.com
.
- Follow-Ups:
- Re: Need a little part ID help.
- From: Spehro Pefhany
- Re: Need a little part ID help.
- References:
- Need a little part ID help.
- From: Glenn Ashmore
- Re: Need a little part ID help.
- From: Spehro Pefhany
- Need a little part ID help.
- Prev by Date: Re: PCB maker
- Next by Date: Re: OT: Canada Agrees to be Missile Target
- Previous by thread: Re: Need a little part ID help.
- Next by thread: Re: Need a little part ID help.
- Index(es):
Relevant Pages
|