Re: STA013 problem

Thanks for your reply.

For the sta013, the I2C bus is ued to configure the chip and the SPI
interface (Pins 5,6,7) is used to stream the mp3 data into it. I used
normal IO port to push data so that I need to swap bits before
serialize into the STA013.

The I2C interface is indeed OK as it returns correct chip ID, and so I
think it is OK. I think I should say it more firmly.:)

.

Relevant Pages

  • Re: Structured Programming using Forth
    ... so radically different as that just to program a chip. ... Or if you can execute out of each processor's RAM, ... port a micro-next loop repeats the same instruction word without ... In the case of a port another processor has to write ...
    (comp.lang.forth)
  • Re: 6809 SBC in development
    ... design material will be free and publicly posted as part of the N8VEM ... helps check out the chip selects, data, and address lines to make sure ... Z80 to set up some handshaking. ... attached to the port B of the 8255. ...
    (comp.sys.m6809)
  • Re: LPT port, anyone ?
    ... The chip has to be ... > Input pin to gather the data one bit at a time. ... put a signal into a pin that's pulled high by the chip port. ... >> for just some 5 sensors on one port. ...
    (comp.lang.pascal.delphi.misc)
  • Re: Parallel Port Interface between PIC and PC
    ... >>> would then transmit the readings to the laptop on the robot. ... the laptop has two ports, a USB port and a parallel port. ... >> available chip pins. ...
    (sci.electronics.design)
  • Re: ICD Multi I/O RS232 Port Speed
    ... ICD Multi I/O RS232 Port Speed ... Has anyone tried to upgrade the MIO RS232 ... Seems possible to do a chip replacement. ...
    (comp.sys.atari.8bit)