Re: op amp-based effects loop circuit for guitar amplifier

On 17 Jul 2005 11:37:32 -0700, "Eric" <eerickson_1@xxxxxxxxx> wrote:

>To adapt this circuit for a split supply, +15 would go to pin 8, -15
>to pin 4, and VREF would essentially become ground, correct? If so,
>are C10 and C3 necessary?

Yes, that's correct. In case you take this route, recommended, you can
replace all capacitors by shorts, they're there only to block DC
levels from getting in each other's way. VREF and GRND should be
connected together. It might be an idea to keep C1 and C8 to block
external DC levels from getting into the circuit.

Whatever you do, DO NOT try to use the +B supply for this circuit.

- YD.

--
Remove HAT if replying by mail.
.

Relevant Pages

  • Connection of Vref (Reference Voltage) causing my drive faulty
    ... My circuit is basically designed to obtain 4 signals (namely A, B, C ... the Vcc and Vee of the op-amps used are also connected to the Vref. ... Vref and GND mentioned above are both points on the CD drive also. ... When we take GND as the reference point, ...
    (sci.electronics.design)
  • Re: Circuit to calculate square root of voltage?
    ... I will check this circuit and maybe simulate it. ... > without the need for an extra Vref. ... Speaking of square root circuits and design methodology (another ...
    (sci.electronics.design)