Re: 4-6 LED Color Changing Platform

All of your idea's have been good but not exactly what I'm looking for,
last night I was trying to come up with a circuit that would do what I
wanted it to. I have the principle down but not the knowledge. I was
thinking of using high storage capacitors connected in parralell with
an LED and in series with a resistor to slow charging time to about two
seconds, causing a red LED to phase in. Once the red LED reached full
brightness I would use a yet to be determined circuit to phase in a
yellow LED as the red one dimmed. Then once the yellow LED reached full
brightness I would use the yet to be determined circuit fade in a blue
LED as yellow faded out. Then it would shift from blue to red. If I can
get this circuit to work it should shift through the full color
spectrum at a relaxing four seconds. Any body got any good ideas?

.

Relevant Pages

  • Re: The phase-shift problem revisited...
    ... shift depending on the value of the load resistor! ... shift one way or the other depending on whether ist a coil or a cap ... >else in the circuit. ... >Add just a couple more reactive components and even the most hair shirted ...
    (sci.electronics.basics)
  • Re: Sunrise Lamp circuit
    ... The circuit can be found at ... brightness over a 20 minutes period (use that instead of an alarm ... The problem is that I would like to use a 15 watts ... say 1000uF and the resistor to 100K and see how it goes. ...
    (sci.electronics.basics)
  • Re: Adjusting monitor focus: Sun/Sony GDM-5010 PT
    ... might try and trace out the circuit grom the screen pin on the CRT ... There should be a large value resistor in the circuit. ... down until I find the best brightness. ...
    (comp.sys.sun.hardware)
  • Sunrise Lamp circuit
    ... I'm a total beginner in electronic and I'd need an advice on modifying ... a circuit that I found on the web. ... brightness over a 20 minutes period (use that instead of an alarm ... The problem is that I would like to use a 15 watts ...
    (sci.electronics.basics)
  • Re: LED strobe light
    ... brightness of an LED with ... microcontroller control. ... I have an LED circuit and assembly program using the PIC12F675 on the ... the circuit will deliver around 100mW but for more power just ...
    (sci.electronics.design)