Re: two USB slave:Interface

Davy wrote: 
I want to transfer data stream from one USB slave chip to another USB
slave chip(single direction).
Shall I interface a hub chip between them? Or can I interface them
without a hub chip?
May you please recommend some references?

Any suggestions will be appreciated! 

Best regards,
Davy

You need a USB master, and it needs to manage the transfer from one slave to the other.

If you're early enough in the project keep in mind that IEEE-1394 is peer to peer. It's harder to build a 1394 peripheral, but you can do much more with it when you're done.

--

Tim Wescott
Wescott Design Services
http://www.wescottdesign.com
.

Relevant Pages

  • Re: JOP as SOPC component
    ... order of six lines of code per interface for a point to point connection, ... I think that this is actually the power of SOPC builder. ... When you have a latency aware master and a slave then there is the one ... aware master/slaves to ones that are not, multiple bus masters, etc. ...
    (comp.arch.fpga)
  • Re: CDVD on Iyonix
    ... and put the jumper on slave. ... Therefore you must be using the second interface. ... Well I get the same error and my DVD drive is on the second disc lead ... and set to Master. ...
    (comp.sys.acorn.hardware)
  • Re: i2c/rs232 converter
    ... I have an i2c bus which has a master already. ... interface) and asynchronous serial interface and program it to ... The TWI in AVR's can be used a a slave interface. ...
    (comp.arch.embedded)
  • problem about an interface between sfifo and sopc avalon MM slave
    ... I have created an interface between sfifo and sopc avalon MM slave.The ... same as the way to visit the avallon MM SLAVE component inside the nios ...
    (comp.arch.fpga)
  • Re: Desperate situation
    ... I didn't have any particular problems using the slave interface on ... aware of is that the secondary interface may not support UDMA. ... it was unusual to find CD-ROM drives that ...
    (Fedora)
Quantcast