Re: NZ-USA Voltage Converter Wiring Diagram or Schematic

Rich Grise wrote:
> Hey, Guys? Doesn't anybody remember that? Anybody wanna back
> me up here?

I might toss in the fact that the later generation of 35mm slide
projectors put a heavy duty diode in series with the lamp. The lamp is
rated at 82 volts.

Operating on 117 volts AC, multiplying by .707 and then subtracting 0.7
volts for diode drop gives... 82 volts!

.

Relevant Pages

  • Re: Motorcycle flasher problem.
    ... Mosfet Removed ... The lamp provides a path to the zener. ... With 14 volts more or less ... Then the mosfet goes back in but leave the gate disconnected and the ...
    (sci.electronics.basics)
  • Re: TECH - what would cause matrix lamps to pulse rather than light solid? (more help needed)
    ... flickering matrix controlled lights. ... alligator clip a light across selected pins, the single lamp test ... If I remove the 18V power into the lamp matrix so that the rectifier ... 15 volts AC, no appreciable DC ...
    (rec.games.pinball)
  • Re: Where is lid switch on HP dv6000?
    ...  Try shining a flashlight at the screen from ... volts and quite possibly well up over 1,000 perhaps getting up towards ... An open circuit voltage of around 1500 volts. ... The reason why it is pulsed is because the lamp shorts (low ...
    (comp.sys.laptops)
  • Re: Where is lid switch on HP dv6000?
    ... Try shining a flashlight at the screen from ... As to the inverter: 2,000 volts? ... An open circuit voltage of around 1500 volts. ... The reason why it is pulsed is because the lamp shorts ...
    (comp.sys.laptops)
  • Re: Embryon Flasher Problem
    ... the 43 volts was getting produced on the aux board. ... the ground and isolate the high voltage from the lamp driver board. ... > First, according to the schematics, the auxiliary board puts out 43 ...
    (rec.games.pinball)