Re: Storing bits using schmitt trigger inverters

In article <flZ_e.1795$rl1.1316@xxxxxxxxxxxxxxxxxxxxxxxxxx>,
notthisjoergsch@xxxxxxxxxxxxxxxxxxxxx says...
> Hello Rich,
>
> > Just put the whole schmear in one little CPLD or FPGA or something.
>
> And then watch the ammeter peg and the battery being slurped dry in no
> time ;-)

The Xilinx CoolRunner II parts seem to be pretty low power, though I've not
used one.

--
Keith
.

Relevant Pages

  • Re: Bidirectional Bus
    ... The FPGA is being programmed but the bus does not release. ... few of the Switch pins of the CPLD and I learned that using a pullup ... on one of the pin in the XC2C64A causes all pins to in a pullup state. ...
    (comp.arch.fpga)
  • Re: Bidirectional Bus
    ... data and fpga_cclk into the FPGA the done pin goes high. ... drive the data bus to CPLD and then finally into an external 8 LED ... --SIGNAL ASSIGNMENT ...     if rising_edgethen ...
    (comp.arch.fpga)
  • Re: Bidirectional Bus
    ... data and fpga_cclk into the FPGA the done pin goes high. ... drive the data bus to CPLD and then finally into an external 8 LED ... --SIGNAL ASSIGNMENT ...     if rising_edgethen ...
    (comp.arch.fpga)
  • Re: Bidirectional Bus
    ... The FPGA is being programmed but the bus does not release. ... few of the Switch pins of the CPLD and I learned that using a pullup ... on one of the pin in the XC2C64A causes all pins to in a pullup state. ...
    (comp.arch.fpga)
  • Bidirectional Bus
    ... After programming an FPGA, XC3S250EVQ100, via Slave Parallel through ... an FTDI USB translator and a CPLD, XC2C64AVQ100, which synchronize ... drive the data bus to CPLD and then finally into an external 8 LED ...
    (comp.arch.fpga)