Re: Strip board?
Ignoramus4371 wrote:
> Bill mentioned a strip board, which I kind of liked as an idea for
> implementation of the final circuit. (due to mentioned issue of
> contacts in breadboard going bad after a while). I looked for it on
> ebay and only found some UK items. Is it called differently in the US?
Veroboard is the preferred UK name ( even though that's like calling all
vacuum cleaners Hoovers ).
Graham
.
Relevant Pages
- Re: mic preamp modification
... rex wrote: ... It was hard to read them in the circuit but I didn't see anything ... Graham ... Prev by Date: ...
(sci.electronics.design) - Re: op amp-based effects loop circuit for guitar amplifier
... DO NOT try to use the +B supply for this circuit. ... It's good enough for Marshall and if there's no ... Graham ... Prev by Date: ...
(sci.electronics.design) - Re: Weird transistor failures
... > There's nothing wrong with your circuit - although you're using a pretty ... I'd tend to use 10k in the base connection in such an ... Thanks Graham, I'm actually using 182L's but I have had identical failures ... Prev by Date: ...
(sci.electronics.design) - Re: Gain equations : ref frequency response
... A flat frequency response can only exist into a pure resitive load. ... This only applies to circuits with the load in the plate circuit. ... > Graham, if you reallly want to discuss something here, ... > and as long as that stays well below reflected impedance it is ...
(rec.audio.tubes) - Re: Swimming Gala!
... >One of mine seems to have done just that, adding an accent to the e in ... Probably gone inside to see if it can cause a short circuit. ... Prev by Date: ...
(uk.education.staffroom) |
|
