Ha. Low end ethernet routers

Replaced a wired router after it had gone flaky. The new one has some
kind of built-in TDR cable diagnostics. From my remote access point in
my office I can see that three of the four ports are connected
properly and there is an open at 7/8 meters on the Tx/Rx pair
respectively. There's an unterminated 25' cable plugged into that
port. Not too shabby for about $35 US with rebate.

Also they've upgraded the processor to an ARM9 from ARM7.


Best regards,
Spehro Pefhany
--
"it's the network..." "The Journey is the reward"
speff@xxxxxxxxxxxx Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog Info for designers: http://www.speff.com
.

Relevant Pages

  • Re: Ha. Low end ethernet routers
    ... kind of built-in TDR cable diagnostics. ... From my remote access point in ... my office I can see that three of the four ports are connected ... Wescott Design Services ...
    (sci.electronics.design)
  • RE: PPTP remote access ports dissapear - HELP PLEASE!
    ... ports disappear from the RRAS console. ... Based on my research, SBS have wizard to configure the VPN, we do not need ... Please open Routing and Remote Access console on SBS thru run command ... You have to rerun the CEICW to make sure your SBS 2003 server have right ...
    (microsoft.public.windows.server.sbs)
  • RE: PPTP remote access ports dissapear - HELP PLEASE!
    ... ports disappear from the RRAS console. ... Based on my research, SBS have wizard to configure the VPN, we do not need ... Please open Routing and Remote Access console on SBS thru run command ... You have to rerun the CEICW to make sure your SBS 2003 server have right ...
    (microsoft.public.windows.server.sbs)
  • Re: VPN - RRAS wont set ports
    ... following procedure being a "fix" but not much follow-up as to whether it ... I have right-clicked Server ports and configured WAN Miniport ... > for Remote Access Connections for 5 ports. ... > Click Yes to exit the wizard and restore your pre-wizard settings. ...
    (microsoft.public.backoffice.smallbiz2000)
  • Re: Messenger Service on W2K server
    ... > a lot of conflicting information about what other ports may be used. ... > an IIS RPC proxy that would enable clients to access RPC services ... > behind a firewall through port 80. ... I wasn't sure if it would also break remote access ...
    (microsoft.public.security)