Re: EM Planner Simulation, Capacitors needed.

apple2pomme@xxxxxxxx wrote:

> I want to view EM field of a receiver, conductor is 1/2" wide, form a
> loop of
> about 5" x 5" square. Dielectric is 1/4" thick, Bottom layer is the
> ground.
>
> On one side (out of the 4 sides of the square) of the conductor loop,
> a small gap is opened and a capacitor bridges the gap. Signal is output
> from one end of this capacitor, via another capacitor:
>
> --------------
> | |-----||-----> signal
> | ==
> | |
> --------------
>
> -------------------Grounding
> (please use fixed width font to view the "graph")
>
> The circuit simulation matches well with real device.
> (S-parameter, etc...)
>
> But when it copied to EMPlanner, all capacitors and the port
> info are gone. And without the capacitors, the EM field is
> not correct. How can this be done with any EM packages?
> Ansoft Designer?, ADS?, How?
>
> Thank you very much for help.
>
> Apple
>
Put in the EM model of the capacitor (from device physics).
Are you sure you are not trolling?
--
JosephKK

.

Relevant Pages

  • Re: Low Noise receiving Loop antenna
    ... since the loop and cap are currently parallel, ... leaves me with 2 ends of the loop. ... Disconnect both wires from the capacitor. ... conductor, ie connect the capacitor wires to each side of where you cut ...
    (rec.radio.amateur.antenna)
  • EM Planner Simulation, Can Componemt ( Capacitors, etc..) be present?
    ... On one side of the conductor loop, ... a small gap is opened and a capacitor bridges the gap. ...
    (sci.electronics.cad)
  • EM Planner Simulation, Capacitors needed.
    ... On one side of the conductor loop, ... a small gap is opened and a capacitor bridges the gap. ...
    (sci.electronics.design)
  • Re: loop antenna question...
    ... sort of a very large coil of wire as the input tuned circuit of the first rf ... As the coil gets larger, in diameter, you need fewer turns.... ... change the capacitor, you have to remotely change the parallel capacitor... ... So you have this rather large loop, inductor, and you have it's ...
    (rec.radio.amateur.antenna)
  • Re: HIGH Q CAPS FOR VLF LOOP ANTENNA?
    ... >expect the 9 ohms of inductive reactance to cancel out the -9 ohms of ... >capacitive reactance leaving only the sum of the AC resistance ... >unconnected capacitor terminal and the unconnected wire end. ... >building a parallel tuned loop. ...
    (rec.radio.amateur.antenna)