Timer circuit to reset router

Hello,

I am trying to build a circuit which will turn off the power supply to my router once every now and then (e.g. I want to hard reset it once every 4 hours when I am not at home).

Any ideas where I should start? The more common timer circuits seems to need a trigger of some sort. Thanks!

Horace
.

Relevant Pages

  • DSL Line dropping, need cable pull for ATM interface to come alive
    ... All seems well apart form one circuit where the installed Cisco 828 ... About 30 seconds after the cable is reconnected the router ... encapsulation aal5mux ppp dialer ... transport preferred all ...
    (comp.dcom.sys.cisco)
  • Re: Tiscali BB with Static IP
    ... off the "static DHCP" argument? ... There are "Static " settings for the router - I just wondered if anybody ... I'm a little curious about the use of DHCP on an ADSL circuit. ... configuration manually and start sending and receiving packets. ...
    (uk.telecom.broadband)
  • Throughput Issue - Packet Loss
    ... I have a 2821 router connected to a 100Mb Ethernet WAN Circuit. ... Having removed the QoS at both ends it made no difference through the day, however, on an evening the circuit seems to run clear. ... We called the carrier and they removed their rate limiting on the circuit, they see no interface errors, drops etc on their switches connected to our routers. ... Our router likewise show no errors on the WAN interface between us and the NTU's at either end. ...
    (comp.dcom.sys.cisco)
  • Re: using home wiring for ethernet connection
    ... household wiring to connect the Slingbox to the router. ... different electrical circuit than my Slingbox/TiVo/cable box circuit. ... Anyone want to be my "electrician buddy" on this one? ... Corinex PowerPhase Coupler - Model D3 ...
    (alt.home.repair)
  • Re: Repairing Lightning damage
    ... I opened the case up and started tracing the circuit. ... I opened up a fried D-Link router once. ... before I was beaten into submission and bought a $400 Cisco unit which has ... won't brand LinkSys shite with the Cisco logo. ...
    (sci.electronics.repair)