Re: Timer circuit to reset router
On Wed, 22 Feb 2006 14:40:16 -0500, in sci.electronics.design Horace
<horace@xxxxxxxxxx> wrote:
Hello,
I am trying to build a circuit which will turn off the power supply to
my router once every now and then (e.g. I want to hard reset it once
every 4 hours when I am not at home).
Any ideas where I should start? The more common timer circuits seems
to need a trigger of some sort. Thanks!
Horace
CD4060 counter, from memory, might do the trick, clock it, derived
from the mains supply and select one of the outputs to pulse a mains
relay.
But maybe a less error prone router would be better.
martin
.
Relevant Pages
- DSL Line dropping, need cable pull for ATM interface to come alive
... All seems well apart form one circuit where the installed Cisco 828 ... About 30 seconds after the cable is reconnected the router ... encapsulation aal5mux ppp dialer ... transport preferred all ...
(comp.dcom.sys.cisco) - Re: Point to Point T1 with Cisco 1841 Routers
... point 1841 routers for a new WAN to our remote office. ... and that night got a lot of alerts saying the circuit was down. ... checked it in the morning and on my side, the router had a lot of CRC ... Sounds like clock slips. ...
(comp.dcom.sys.cisco) - Re: Point to Point T1 with Cisco 1841 Routers
... point 1841 routers for a new WAN to our remote office. ... and that night got a lot of alerts saying the circuit was down. ... checked it in the morning and on my side, the router had a lot of CRC ... Sounds like clock slips. ...
(comp.dcom.sys.cisco) - Re: Tiscali BB with Static IP
... off the "static DHCP" argument? ... There are "Static " settings for the router - I just wondered if anybody ... I'm a little curious about the use of DHCP on an ADSL circuit. ... configuration manually and start sending and receiving packets. ...
(uk.telecom.broadband) - Throughput Issue - Packet Loss
... I have a 2821 router connected to a 100Mb Ethernet WAN Circuit. ... Having removed the QoS at both ends it made no difference through the day, however, on an evening the circuit seems to run clear. ... We called the carrier and they removed their rate limiting on the circuit, they see no interface errors, drops etc on their switches connected to our routers. ... Our router likewise show no errors on the WAN interface between us and the NTU's at either end. ...
(comp.dcom.sys.cisco) |
|
