Re: How to connect this transistor NTE199?


markbradley2006@xxxxxxxxx wrote:
Hi all:

I have a project that uses transistor NTE199. In this transistor the
disposition of pins is strangely as it follows:
^
No ----------------------------------|


! ! !
! ! !
e c b

with the flat part in front of you. It is to say that in this
transistor the base is not at the center.

Yes


On the other hand the circuit says that a resistor must be connected to
the central pin of the transistor.

Yes


So the question is:

How to connect this resistor to the transistor.
1) To c

No

2) To b

Yes


Thanks in advance for any comment.

It's a very common component. Perhaps your local high school science
teacher can help you understand it. Rather than asking hundreds or
thousands of people around the world.

.

Relevant Pages

  • Re: Vintage Sony discman d-7 dead
    ... The other side has 4 pins. ... but it goes through a resistor to the VCC of the PWM IC. ... and the other one goes to the base of a transistor. ... Also, i have no idea, but when you flip the power switch, does the LCD ...
    (sci.electronics.repair)
  • Re: Creature Lamp Matrix Problems
    ... reflow the pins on the light board. ... >> if you can get the row to work, replace the transistor. ... >>> MIKE ...
    (rec.games.pinball)
  • Re: Creature Lamp Matrix Problems
    ... reflow the pins on the light board. ... > If it's a whole row, double check the tip102 transistor for that row or ... >> I'm shopping a Creature and have run into a lamp matrix problem... ... >> MIKE ...
    (rec.games.pinball)
  • Re: Creature Lamp Matrix Problems
    ... reflow the pins on the light board. ... double check the tip102 transistor for that row or ... > I'm shopping a Creature and have run into a lamp matrix problem... ...
    (rec.games.pinball)
  • Re: Need help with IR Detector
    ... The Image is very clear so I understand what pins are what but, ... circuit diagram docent say what transistor or resistor to use. ...
    (comp.robotics.misc)