Re: How to connect this transistor NTE199?


<markbradley2006@xxxxxxxxx> wrote in message
news:1140819360.252555.295170@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Hi all:

I have a project that uses transistor NTE199. In this transistor the
disposition of pins is strangely as it follows:

! ! !
! ! !
e c b

with the flat part in front of you. It is to say that in this
transistor the base is not at the center.

On the other hand the circuit says that a resistor must be connected to
the central pin of the transistor.

So the question is:

How to connect this resistor to the transistor.
1) To c
2) To b

Thanks in advance for any comment.



If the circuit you're looking at specified that the transistor be a NTE199 unit,
then connect the resistor to the center pin (Collector). If the circuit
specified a different transistor, and the NTE199 is a substitute, then you'll
have to research the originally specified part and see if the pinout is the same
as the NTE199 part. If they have the same pinout, then you're home free.
If different, then make the connection according to the specified part. That
is, if the center pin on the original part is the base, then connect your
resistor to the base pin on the NTE199.
Think, man!!! Use your skull for something other than a hatrack!!

--
Dave M
MasonDG44 at comcast dot net (Just substitute the appropriate characters in the
address)

Never take a laxative and a sleeping pill at the same time!!


.

Relevant Pages

  • Re: astable multivibrator issues - 2N3904s work, but not TIP31As
    ... the circuit would not oscillate unless I briefly disconnected then re- ... The main issue folks have is that they forget to bypass the power supply, ... As a side note, the easy way to build a square wave oscillator from a cmos 555 is to connect the output pin to a resistor, then connect the other side of the resistor to ground through a capacitor. ... For your application, you might use the discharge to directly drive one LED, and have the other LED driven by a power PMOS or PNP transistor. ...
    (sci.electronics.basics)
  • Re: Simple mosfet question
    ... describe the simple circuit and I think it will be clear: ... There is a 2N7000 N-ch mosfet transistor, ... a resistor, 10k, and the other side of the 10k resistor is tied to a ... Need to learn how to apply control theory in your embedded system? ...
    (sci.electronics.design)
  • Re: Help! Capacitive coupled transistor setup
    ... It is the reference circuit from Kodak for their CCD imaging sensors. ... with the emitter of each transistor and its corresponding ... resistor to the base of one of the transistors. ... end of the resistor to V high and observe the LEDS, ...
    (sci.electronics.design)
  • Re: Q: Transistor as a switch with pull down ?
    ... Emitter is grounded. ... digital output pin the base will be floating if the PIC failes to ... pulldown resistor at 10k and replace the IO pin to base with say a 1k ... defined as an input there are no chance of the base of the transistor ...
    (sci.electronics.basics)
  • Re: Newbee: Optocoupler to BasicStamp
    ... > the circuit to work. ... > pulled up by a 10K resistor. ... > I cant get the Stamp to detect on/off states. ... The input to the base of a transistor is what normally turns it on. ...
    (sci.electronics.basics)
Quantcast