Re: PCB
"Jackie" <Shuangshuang.Zhou@xxxxxxxxx> writes:
What is "Footprints"?
Footprints are the copper patterns that represent a component's
physical layout on the board - pins, pads, silkscreen, holes, solder
mask, etc.
.
Relevant Pages
- Re: SMD Electrolytics
... I guess the pads probably rip off with G shock. ... Why don't you try slipping the leads through small holes in the PCB ... 1st solder the throughhole part to the base, ... A small bit of FR4 with holes and two pads ought ...
(sci.electronics.design) - Re: SMD Electrolytics
... I guess the pads probably rip off with G shock. ... Why don't you try slipping the leads through small holes in the PCB ... Wouldn't it be nice if every component were SMD? ... 1st solder the throughhole part to the base, ...
(sci.electronics.design) - Re: SMD Electrolytics
... I guess the pads probably rip off with G shock. ... I wonder if there's little bases I can put on throughhole capacitors ... 1st solder the throughhole part to the base, ... A small bit of FR4 with holes and two pads ought to do it nicely. ...
(sci.electronics.design) - Re: What gap to use on solder mask?
... >> ground plane) as well as for the solder mask. ... >> come to within .020 inches of the pads and traces and the solder mask will ... footprint libs have them the same size as the pad. ...
(sci.electronics.design) - Re: What exactly does this mean? (pcb fab)
... All the vias are masked except ... Is it od why I am puting a solder mask over them them? ... All the smt pads, of course, can't have solder resist. ... suppose to have holes in them or the board is useless. ...
(sci.electronics.design) |
|
