Re: NiMH charger using MAXIM 712

Thank for that. I just checked. The holder has almost not voltage drop
0.01V-0.02V, compared with charging voltage, this can be ignored, and
connection between batteries and the contacts is good.

.

Relevant Pages

  • Re: NiMH charger using MAXIM 712
    ... 0.01V-0.02V, compared with charging voltage, this can be ignored, and ... connection between batteries and the contacts is good. ... usually poor matching of new - or older - ...
    (sci.electronics.design)
  • Re: Firepower Sound Help - Part 2
    ... The game boots into audit mode: ... Most likely the battery holder is corroded and the batteries are not ... making a connection to power up the 5101. ...
    (rec.games.pinball)
  • Re: OT Solar Accent type lights
    ... My question concerns the AA batteries. ... because the charging voltage and the low-battery cutoff voltage ... If it was designed for NiCd, ...
    (alt.autos.toyota)
  • Re: anyone make stainless battery bolts?
    ... the terminals and anti-seize on the bolts, but the bolts rust if you ... symptom of too high a charging voltage. ... from the regulator the terminals should stay clean for a long time. ... I've gone through three batteries since I ...
    (rec.autos.tech)
  • Re: W00T! I got batteries
    ... AGM batteries have slightly different charging voltage ... >>requirements than flooded batteries. ... >>right charger makes the batteries last longer. ...
    (alt.sysadmin.recovery)