Who can help me think about the negative feedback in analog circuit?
In the voltage-current negative feedback,what is the value of the
negative feedback voltage of the output voltage?
It says that "Vref=Vo*Re1/(Re1+Rf)" in the text book,why is that?
Should I consider the output resistance of the emission pole of the
first transistor?I think the Re1 should be taken place by
Re1//(rbe/(ß+1)),and there also should be an equivalent negative
voltage that equals to be vi*rbe/(Re1*(ß+1)).
I think there may be something wrong with my consideration, who can
help me?
Is there any way to upload the schematic?
Thanks in advance!
.
Relevant Pages
- Re: LM323-K adventure and lesson
... > regulated output rose by .67v by adding a 1N4007 diode. ... the forward bias voltage drop of a diode is ... If the regulator is running under voltage -- then you should adjust the output voltage by installing the diode forward biased on the regulator's ground pin. ... Can also do this with a resistor for a more predictable result. ...
(rec.games.pinball) - Re: Getting output voltage for a sound card
... card is not above specified level. ... I have observed that different cards have different output voltage, ... percentage or dB change versus mixer control. ...
(microsoft.public.win32.programmer.mmedia) - Re: Need to drop 6v to 5v for my DC video players at 2A
... I've got 2 12 volt DC cigeratte lighter plugs power supplies that put ... resistors to drop the auto socket voltage down to the output voltage. ... In the most sleasy designs the output voltage at any particular setting ... upon how much current is drawn by the load that you attach. ...
(sci.electronics.basics) - Re: Voltage Regulators
... And the divider voltage must be the desired output voltage minus the nominal difference voltage between the output and the reference pin. ... Since the nominal difference between the reference pin voltage and the output voltage is 1.25 volts, there will be that much voltage across the top resistor of the reference divider, so it must be no more than 1.25/.01=125 ohms. ...
(sci.electronics.basics) - Re: recommended components for audio AGC?
... You won't ever get much quieter that 34 dB SPL, ... output voltage of 5 V; ... 'radio' type AGC characteristic, where the output voltage is very nearly ...
(sci.electronics.design) |
|
