Shunt Resistors?

Hi guys,

Im working on a 30A/120V power meter and would like to use a shunt
resistor? what value do you guys recommend for my application? Any
manufacturer's in particular?

Thanks In Advance.

.

Relevant Pages

  • Re: Shunt Resistors?
    ... Im working on a 30A/120V power meter and would like to use a shunt ... what value do you guys recommend for my application? ...
    (sci.electronics.design)
  • Re: changing my VMeter from 0.25A to 25A
    ... >I have a volt meter which can reads DC current up to 0.250A ... Most multimeters have a shunt resistor built-in, ... voltmeter to read voltage across that shunt resistor. ...
    (sci.electronics.basics)
  • Re: 34330A 30 A Current Shunt any cheaper alternative?
    ... expensive after adding the calibration cost. ... buy a ready-made shunt to save time. ... If you put 4A through a 0.05 ohm resistor, you have a 0.2V drop across ...
    (sci.electronics.design)
  • Re: Current Meter for 12V Solar System
    ... shunt IF you start with a 50ua meter movement. ... might dissipate 1 watt in the shunt with a 40 amp load. ... I've looked into setting up a shunt resistor in ...
    (sci.electronics.basics)
  • Re: 34330A 30 A Current Shunt any cheaper alternative?
    ... expensive after adding the calibration cost. ... buy a ready-made shunt to save time. ... If you put 4A through a 0.05 ohm resistor, you have a 0.2V drop across ... What is it so special in agilent 34330A? ...
    (sci.electronics.design)