Re: Resonator Tolerance

jacky.newsgroup@xxxxxxxxx wrote...

From a signal seen in the ocilloscope, how can I tell what
the should the tolerance be?

If you have a recent vintage digital scope, it may be able to
make quasi-accurate measurements for you, but an analog scope
most likely cannot get you much past 0.5%, you'll be measuring
the scope not the component. Go grab a frequency counter.


--
Thanks,
- Win
.

Relevant Pages

  • Re: cheap USB analyzer based on FPGA
    ... differential input of the FPGA? ... My scope is old and unaccurate, i'm not sure of the exact acceptable level ... the 1ms frame are still threre but no data ... However concerning the 5V tolerance, i'm not sure it is necessary since ...
    (comp.arch.fpga)
  • Re: cheap USB analyzer based on FPGA
    ... My scope is old and unaccurate, i'm not sure of the exact acceptable level ... Theses frames have a duration of ~200 - 250 us when live video is enabled ... the 1ms frame are still threre but no data ... However concerning the 5V tolerance, i'm not sure it is necessary since ...
    (comp.arch.fpga)
  • Re: Modulation meter accuracy?
    ... restoring an old TRC-455. ... Some of the cheapo ones may be as bad as 25% tolerance... ... The scope is a much better tool... ... Do I inject a 1 KHz tone right into the mic plug, or do I have to go thru the ...
    (rec.radio.cb)
  • Re: Modulation meter accuracy?
    ... restoring an old TRC-455. ... Some of the cheapo ones may be as bad as 25% tolerance... ... The scope is a much better tool... ...
    (rec.radio.cb)