Re: icl7107 scale factor

On 30 Apr 2006 10:14:50 -0700, the renowned "maxi"
<maxitubo@xxxxxxxxxxx> wrote:

Probably i dont't explicate me well.

i have a signal that rise from 0 to 600 mV at max.

I should use the 2v full scale for haven't overflow.

But i've only 3 digit precision.So i'd like to mesure from 0 to 600mv
with all 3 1/2 digit precision.

Example: with 2 volt full scale at 300mV the dyspaly show 0.300 and so
on.I'd like that dyspaly show 300.0.

Probably is not possible

Not possible. You could make it read 300. (not 300.0).


Best regards,
Spehro Pefhany
--
"it's the network..." "The Journey is the reward"
speff@xxxxxxxxxxxx Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog Info for designers: http://www.speff.com
.

Relevant Pages

  • Re: icl7107 scale factor
    ... Probably i dont't explicate me well. ... i have a signal that rise from 0 to 600 mV at max. ... I should use the 2v full scale for haven't overflow. ... with all 3 1/2 digit precision. ...
    (sci.electronics.design)
  • One crime committed every two minutes by British youths
    ... "A report from the Youth Justice Board disclosed that youngsters aged ... "The scale of the problem was highlighted by a 20 per cent rise in the ...
    (uk.legal)
  • Re: One crime committed every two minutes by British youths
    ... "The scale of the problem was highlighted by a 20 per cent rise in the ... number of children convicted for violent offences over the past three ... Ret. ...
    (uk.legal)
  • Re: Any suggestions for HO gradient?
    ... Can anyone suggest the minimum length required to meet a rise of 100mm ... or 4 inches in HO scale. ... http://www.deepsoft.com/ -- Binaries for Linux and MS-Windows ...
    (rec.models.railroad)
  • Re: icl7107 scale factor
    ... I should use the 2v full scale for haven't overflow. ... But i've only 3 digit precision.So i'd like to mesure from 0 to 600mv ... with 2 volt full scale at 300mV the dyspaly show 0.300 and so ...
    (sci.electronics.design)