Re: designing of frame grabber


Michael A. Terrell wrote:
linnix wrote:

cs_posting@xxxxxxxxxxx wrote:
me wrote:

The rf modem involved in this part of project is transmitting only
digital data, so I think I just need to take care of data(in bits of
1's and 0's which are coming ), since they are already in digital form
only so I dont require any video processor or ADC.right?

In that case you don't need to worry about USB or cameralink either
since you are getting data from the radio modem. All you have to do is
buffer and prep it for the ultimate consumer.

Pity the guy working on the flight system though. Easiest fix up there
is probably a little processor module running linux, if that supports
the camera in question.

We are working on a similiar system, but it's on the ground.
We are using a PCI (USB is too slow) frame grabber using
the Phillips SAA7134. Resolution is good enough at 700x500.
However, there are several problems:

1. Image is monochromatic only.
Still trying to figure out if its a hardware or software issue.
I know color is an add-on to composite video.
When bandwidth is limited, the color signals might not get through.

Or the software is not decoding the color data.

2. Hard to track start of frame.
The picture has a dark bar near the bottom, which could be
the retrace dead time. But sometimes it misses the frame
altogether.

3. Need 8 to 12 input jacks, which is difficult to place on the
PCI bracket without a custom connection system.

Any suggestions?


How about a second plate, or use a single connector with a harness to
convert single inputs to the single connector?

Yes, but they have to be shielded cables.
The alternative is an external video mux before coming to the internal
board.
There would be channel selection logics between them.
Digital selection cable is probably easier to connect than multiple
analog
cables.



--
Service to my country? Been there, Done that, and I've got my DD214 to
prove it.
Member of DAV #85.

Michael A. Terrell
Central Florida

.

Relevant Pages

  • Re: designing of frame grabber
    ... Michael A. Terrell wrote: ... I know color is an add-on to composite video. ... or use a single connector with a harness to ...
    (sci.electronics.design)
  • Re: designing of frame grabber
    ... Michael A. Terrell wrote: ... I know color is an add-on to composite video. ... or use a single connector with a harness to ...
    (sci.electronics.design)
  • Re: Cheney on Meet the Press
    ... Michael A. Terrell wrote: ... An even more brilliant pun from the stalker. ... You really do have to fire that useless comedy writer ...
    (rec.crafts.metalworking)
  • Re: Transferring info from old computer
    ... Boot the XP, ... "Michael Stevens" wrote: ... > It is concieviably possible to connect the computers via crossover cables, ... Install the hard drive with the proper jumper and cable configurations. ...
    (microsoft.public.windowsxp.general)
  • Re: Tube Audio Amp question
    ... Michael A. Terrell wrote: ... handle the power? ... The newer transmitter was installed by the ...
    (sci.electronics.repair)