Connection from uC to TFT color Display 2"

Hi,

does anyone have any idea how to connect small TFT color display 2"
together with microcontroller? The display has driver like HX8312.

I'd like to connect it to either to renesas microcontroler or
microchip.

Does anyone know which capacitors are fine for bypass or decoupling
capacitors?

Anyone know how to reach some schematic like example?

Best regards
Zdenko

.

Relevant Pages

  • Re: Connection from uC to TFT color Display 2"
    ... does anyone have any idea how to connect small TFT color display 2" ... together with microcontroller? ... The display has driver like HX8312. ... Does anyone know which capacitors are fine for bypass or decoupling ...
    (sci.electronics.design)
  • Re: Using Ndis WDM with a 32 bit microcontroller
    ... Everything depends on your microcontroller hardware. ... Windows NDIS miniport driver which will talk to the microcontroller hardware ... Or should i develop a WDM pci driver and use it with Ndis WDM driver? ...
    (microsoft.public.development.device.drivers)
  • Re: How PC parallel port Is connected internally?
    ... The hardware i have used in the project is AT89S52 microcontroller ... ADC0804), output, LM35 heat sensor and a IDC connectors so that ... Communicate with device through parallel port attached to port 1 of ... I mean it is working fine with NT Driver. ...
    (comp.arch.embedded)
  • Re: 300 mA from a microcontroller pin
    ... I have a 14-pin PIC microcontroller, ... and high impedance. ... Can someone please suggest a driver chip so that I can effectively ... You will probably need two pins for the control---one to enable ...
    (comp.arch.embedded)
  • Re: 0xc0000011 (USBD_STATUS_XACT_ERROR) ?
    ... The microcontroller has to TELL it there is data ... The firmware running in the microcontroller is from Philips. ... DMA transfer if the device supports DMA? ... Their driver does not provide any interface or document for me to do ...
    (microsoft.public.development.device.drivers)