Re: sanding off chip markings?
- From: Spehro Pefhany <speffSNIP@xxxxxxxxxxxxxxxxxxxxxxx>
- Date: Wed, 07 Jun 2006 14:47:13 -0400
On Wed, 07 Jun 2006 17:19:07 GMT, the renowned Joerg
<notthisjoergsch@xxxxxxxxxxxxxxxxxxxxx> wrote:
Hello Michael,
Two additional reasons I bought it:
1. I thought it would be a lot lighter to carry on plane trips than my
CD-MP3 player. Only later did I remember that it might cause
interference with the aircraft navigation.
That would most likely bring the goons out. I doubt these things would
be good in terms of EMI. Come to think of it, I don't even have an MP3
player. Now I am feeling old...
2. In case of a nuclear strike against us, or equivalent catastrophe,
having a radio like this might come in handy. (Better than nothing at
all.)
Mine almost would lose tune when one of our dogs sneezed. When walking
through the hallway here it wasn't able to play the same station from
one end to the other. Pathetic. I'd take a classy old 6-10 transistor AM
radio. Much better and runs for days on normal batteries, not some
boutique coin cells.
I'll take my old analog Panasonic RF-B20 multiband over most of the
new stuff. 'Made in Japan' quality, good speaker, and it runs for ages
off of 3 AA cells if you don't crank the volume up too much. Wasn't
particularly cheap when I bought it 15-20 years ago, but it's been a
faithful companion since.
http://www.universal-radio.com/catalog/portable/rfb20.html
Best regards,
Spehro Pefhany
--
"it's the network..." "The Journey is the reward"
speff@xxxxxxxxxxxx Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog Info for designers: http://www.speff.com
.
- Follow-Ups:
- Re: sanding off chip markings?
- From: Boris Mohar
- Re: sanding off chip markings?
- From: Michael
- Re: sanding off chip markings?
- From: Joerg
- Re: sanding off chip markings?
- References:
- sanding off chip markings?
- From: mrdarrett
- Re: sanding off chip markings?
- From: Joerg
- Re: sanding off chip markings?
- From: mrdarrett
- Re: sanding off chip markings?
- From: Joerg
- Re: sanding off chip markings?
- From: Richard Henry
- Re: sanding off chip markings?
- From: Joerg
- Re: sanding off chip markings?
- From: mrdarrett
- Re: sanding off chip markings?
- From: Joerg
- sanding off chip markings?
- Prev by Date: Re: sanding off chip markings?
- Next by Date: Re: LLP - Leadless Leadframe Package (ops;)
- Previous by thread: Re: sanding off chip markings?
- Next by thread: Re: sanding off chip markings?
- Index(es):
Relevant Pages
|