Re: Amusing problem about DC polarity

I do that all the time. My eyes are not what they were, and if I pick
up something with two pins, it might be a black box, or a little black
diode, or multicolored. If it's multicolored, like stripes, I'm
thinking resistor. Or, one stripe, a diode. 3 pins, transistor.
Although, a bipolar transistor is just 2 diodes. And a phototransistor
only has two pins (sometimes.) Bottom line, stick it on an ohm meter.
First one way, then the other way. If it's DC, you will get 1) a very
high resistance one way, and a not so high resistance the other way, 2)
the same resistance both ways, could be zero, infinity, or other 3) you
get a fairly high resistance both ways, but the harder you look at it,
you can't quite make up your mind which way has the higher resistance
4) your analog ohm meter acts a little funny, but your digital meter
makes no sense at all

1) when you read the lower resistance, look at the red probe. That's
ground. If that answer is wrong, then I'll correct myself right now
and say the red probe is positive.
2) it's a resistor, or open circuit, or closed circuit.
3) you've got your sweaty fingers squeezing the probe leads too hard
and shunting your body resistance across the ohm meter. Don't do that.
4) probably a capacitor
5) your ohm meter doesn't work now. You should have checked it it
with a volt meter first because it might be a battery. And if the box
is black, about the size of a bread box, and weighs about 20 pounds,
it's a 12v car battery, and you shouldn't have had to test it in the
first place.


siliconmike wrote:
Imagine a black plastic box that takes in DC power but has no polarity
markings on its power socket.

The problem is to experimentally determine the correct DC polarity
without opening the box and without letting the box die.

How close can we come?

.

Relevant Pages

  • Re: Amusing problem about DC polarity
    ... Or, one stripe, a diode. ... pins, transistor. ... only has two pins Bottom line, stick it on an ohm meter. ... high resistance one way, and a not so high resistance the other way, 2) ...
    (sci.electronics.design)
  • Re: Human Electrocution: How is the resistance not ridiculously high?
    ... I bet you'll find a serious change in resistance. ... I have intact skin on my hand, and intact skin on my foot. ... I put an ohm meter across my hand and foot and measure 2 megaohms. ...
    (sci.electronics.basics)
  • Re: The truth about decibels
    ... >>Cable impedance at DC is a perfectly sensible concept. ... Apply your Ohm meter to an infinitely long sample of it. ... drop of the cable will mess up the measurement. ... if you take a full second to measure the resistance, ...
    (sci.electronics.design)
  • Re: Bose speakers impedence?
    ... Impedance is a vector sum of resistance and either Inductive or Capacative ... reactance. ... The best way to check is with an ohm meter ...
    (rec.audio.car)
  • Re: T68bis "Minus Zero" potato amp circuit and layout now online
    ... any of the pins will 'see' is 55 ohms to the pot. ... the resistance 'seen' will be 0. ... At the frequencies in question you cannot ignore the ... properly trained engineer ignores them. ...
    (rec.audio.tubes)
Loading