Re: Need someone to design a light pulsing circuit

On 29 Jun 2006 14:33:32 -0700, "SirQwerty" <tdonovan@xxxxxxxxx>
wrote:

Hi

I've made a cube lamp out of unpopulated circuit boards. It looks
great but I would like it to do more. I want the single 60w bulb in it
to pulse, slowly going from dim to bright and back to dim and so on.
It would pulse at a slow constant rate. If the ambient noise level
rises I would like the lamp to pulse correspondently faster. As the
noise level falls it would go back to a steady slow pulse.

I have hooked up a manual dimmer switch to demonstrate the effect. If
anyone would like to see a small video of the lamp please email me.

I know very little about electronics and there is no hope I could make
this circuit.

If anybody would like a challenge email me and we can discuss it.

---
Are we talking about money???


--
John Fields
Professional Circuit Designer
.

Relevant Pages

  • Need someone to design a light pulsing circuit
    ... I've made a cube lamp out of unpopulated circuit boards. ... It would pulse at a slow constant rate. ... noise level falls it would go back to a steady slow pulse. ...
    (sci.electronics.design)
  • Fundamental Limits to Curts Nets
    ... For now that means pointing out some fundamental limits ... Imagine an xor circuit with the output fed back into one of the inputs (so ... generate output pulses until a new pulse arrives on the input line. ... Biological neural nets do not have that problem. ...
    (comp.ai.philosophy)
  • Re: coutdown 555 timer values?
    ... >> The tricky part is shortening up that first 555 pulse in astable mode ... >will begin the first timing cycle at about 1/3rd of the total voltage, ... which will make the circuit insensitive to ... >> forces all of the inverting inputs to the comparators lower than ...
    (sci.electronics.basics)
  • Re: coutdown 555 timer values?
    ... >>>counter and using 555 to generate a 30 sec pulse seems like a good idea. ... In this circuit we use six comparators with references derived ... John Fields ...
    (sci.electronics.basics)
  • Re: watering system, second attempt.
    ... >>after the comments on my first version, i've redesigned the circuit using ... It's meant to send a 1s 13A pulse through an electromagnet at the ... The tank is normally empty, with the magnet holding the ballcock shut ... the valve latches shut again, and then the tank drains slowly through the ...
    (sci.electronics.basics)