Re: Need someone to design a light pulsing circuit

I can think of how you could build a circuit with a simple (and
extremely cheap) 555 timer, but the "ambient noise" part has me
confused. Is there variable noise generated from light bulbs that I
don't know about? The circuit you are requesting would not be very
large or difficult to build from a 555 timer - the hardest part would
be to make it variable, which also is probably not too difficult - but
I would need you to elaborate on the noise part before I thought about
it further.

jalegris@xxxxxxxxxxxx wrote:
Mochuelo wrote:
On 29 Jun 2006 16:17:13 -0700, "SirQwerty" <tdonovan@xxxxxxxxx> wrote:

I can't afford a professional design. This is only a hobby. I only
have three of these light boxes so I can't afford an expensive design.
I could possibly trade something for the circuit. Check out
www.walkingdrives.com.


A hobby?

"Please contact us at sales@walkingdrives or tony@xxxxxxxxxxxxxxxxx
before purchasing online to make sure of the availability and delivery
date of item(s) you wish to order."

You are selling other products but don't want to sell this one?

Give the guy a break. He's an artist. Have you seen his shipping
crates? They alone are worth the $65 to $200 he charges for custom-made
clocks.

Warning to the original poster: you should not try to market a direct
120 Volt line-powered product or else you'll invite safety related
problems such as overheating and CSA or UL certification, which you
ceriainly cannot afford. Use either an AC adapter or batteries. Then
you can assemble them yourself without fear of getting zapped by
electricity or lawyers. For a design, email me.

--
Joe Legris

.

Relevant Pages

  • Re: inductor sizing
    ... The mosfets will be PWM controlled ... switching frequency which we call noise. ... Please post your circuit and we ... diode and inductor can either be one per mosfet in parallel to reduce ...
    (sci.electronics.design)
  • Re: 4541 timer IC dies
    ... > timer IC in our stair light timer didn't help I built a new one from ... > circuit, the timer IC stopped working, drew 0.7 A and got hot. ... I suspected a transient after ... The CMOS process isolates the MOS transistors in the chip with PN ...
    (sci.electronics.design)
  • Re: Any OR gates with good noise immunity?
    ... > routing a copper track from one board to another via a common 'mother' ... > an ideal aerial for this noise, even though the entire circuit is ... Since you have a grounded metel enclosure, the best solution would be to ...
    (sci.electronics.design)
  • Re: Dosing Control: Timing Your Grinder #2
    ... How about a replacement mechanical knob timer from a Mazzer? ... consistent exact amount of grind for a particular time period. ... MP> 1) 555 timer circuit. ... but in my circuit I put a button on pin 4 and then tied the ...
    (alt.coffee)
  • Re: TV preamp FET choice
    ... and other with low noise 5ghz bjt, the spec sheet for both gave aprox 1db NF ... at i beleive 50ohm src impedance, wich i beleive is adding hardly any noise. ... I managed to get the circuit small enough to put it inside a coaxial plug ... inductor design etc. ...
    (sci.electronics.design)