Re: **LOW** Power applications


Ken Smith wrote:
In article <1157390698.941191.230410@xxxxxxxxxxxxxxxxxxxxxxxxxxxx>,
linnix <me@xxxxxxxxxxxxxxxxxx> wrote:
[...]
The trick is power management. At 10mA, the Max232 is drawing several
time more power than the micro at idle. I am redesigning my circuit to
turn it on only when a cable is connected (A2D the DTR signal). The
Max232 (started out at Maxim, second sources from many) is about $1,
but it requires 4 1uF caps (a penny each). Siplex actually has a part
with build in caps, but they wants $3 each.

You can power the output circuit from the connected RS-232. This would
require that you not use the MAX232. I'm thinking along these lines:


I have tried charge pump circuits from cable signals (DTR and RX).
They work for low speeds and duty cycles, but fails under certain
conditions. The Max232 is more reliable, although for the price of
more PCB spaces.


If Vcc is at least 3V, this will work. With the RS-232 cable not plugged
in, the circuit floats and only the leakage in C1 matters. The P-MOSFET's
leakage is taken out of the picture.

My Vcc goes down to 1.8V, when the BOD kick-in and shut it down.

.

Relevant Pages

  • Re: 12 LED resistance circuit help
    ... be more humble and merely post "Circuit designer"? ... >Perhaps "dissipate more power" would have been more appropriate than ... "Since there are two LEDs in series, one may hog more current than the ... >> dissipation spec of an LED with Vf max in series with an LED with Vf ...
    (sci.electronics.basics)
  • This guy is a crackpot, but what is the most obvious reason why?
    ... Analog Audio Power Amplifier Design ... This author's experience with analog audio circuit design extends over ... a period of 50 years -- the era of the vacuum tube, ...
    (rec.audio.tubes)
  • Re: Ground Busses
    ... Someone suggested I write an article on power and grounding techniques ... be no need to worry about power and ground topologies or wire routing. ... By definition, every circuit forms ... strong field from a transformer or choke) exists in the loop, ...
    (rec.audio.tubes)
  • Re: Ground Busses
    ... Someone suggested I write an article on power and grounding techniques ... be no need to worry about power and ground topologies or wire routing. ... By definition, every circuit forms ... strong field from a transformer or choke) exists in the loop, ...
    (rec.audio.tubes)
  • Re: How do I ground a chassis with only a 2-conductor power cable?
    ... The purpose is to transmit about 80 feet, give or take, so I don't ... I do realize that if I go over a certain radiated power limit (which I ... circuit draws from the supply, which I don't recall ever seeing going ... the radio to show it's powered up)... ...
    (sci.electronics.design)