Re: Turning on a MOSFET from 0-5V

Collector of NPN thru connector to board with MOSFET and pull-up
resistor to +12V ;-)

Well, correct. Of course I was trying to be difficult, if I were not in
the
mood to talk I would be working and not discussing a homework.

Not that I would be cheerfully talking had I anticipated your
hostility,
(or was it that of your ass) but one keeps on learning.

Dimiter

------------------------------------------------------
Dimiter Popoff Transgalactic Instruments

http://www.tgi-sci.com
------------------------------------------------------

Jim Thompson wrote:
On 19 Sep 2006 17:20:19 -0700, "Didi" <dp@xxxxxxxxxxx> wrote:

From base, pull-up resistor to +5V

Ah, expected that - but there is no 5V to be seen on the OP
schematics....
This is a homework, remember :-). The 5V powered hc04 or whatever is
on another board and you don't have a pin on the connector for them :-)
:-)

Cheers,

Dimiter

[snip]

Cheers, my ass. You're just making a feeble attempt to be difficult.

So locate NPN and base pull-up resistor on the board with the logic.

Collector of NPN thru connector to board with MOSFET and pull-up
resistor to +12V ;-)

...Jim Thompson
--
| James E.Thompson, P.E. | mens |
| Analog Innovations, Inc. | et |
| Analog/Mixed-Signal ASIC's and Discrete Systems | manus |
| Phoenix, Arizona Voice:(480)460-2350 | |
| E-mail Address at Website Fax:(480)460-2142 | Brass Rat |
| http://www.analog-innovations.com | 1962 |

I love to cook with wine. Sometimes I even put it in the food.

.

Relevant Pages

  • Re: Q: Transistor as a switch with pull down ?
    ... The relay is connected between +12v and collector. ... digital output pin the base will be floating if the PIC failes to ... pulldown resistor at 10k and replace the IO pin to base with say a 1k ... And if I were sending this line to a connector, ...
    (sci.electronics.basics)
  • Re: Q: Transistor as a switch with pull down ?
    ... The relay is connected between +12v and collector. ... digital output pin the base will be floating if the PIC failes to ... pulldown resistor at 10k and replace the IO pin to base with say a 1k ... And if I were sending this line to a connector, ...
    (sci.electronics.basics)
  • Re: P2B-DS and generic slotkets
    ... >>> the generic sloket and same as before would not boot in dual mode. ... If R3 is a 56 ohm resistor, ... It could be the slocket doesn't ... VID tracks near the edge connector, ...
    (alt.comp.periphs.mainboard.asus)
  • Re: P2B-DS and generic slotkets
    ... >> processors are requesting 2.0 volts instead of 1.65 volts. ... If R3 is a 56 ohm resistor, ... > to the SC242 edge connector. ... > where there is no DIP switch to set the Vcore voltage. ...
    (alt.comp.periphs.mainboard.asus)
  • Re: Need jumper settings on Teac FD-55BV drive
    ... to pin-34 and connected a jumper between the Ready ... of the 50-pin connector to my CompuPro Disk-1 FDC. ... There is also a SIP pull-up resistor near the 34 pin ... but the 55GFR does not have a terminator resistor socket. ...
    (comp.os.cpm)