Re: Building More Powerful Amp



"sahilmaratha@xxxxxxxxx" wrote:

Hello friends .Its sahil wants ur help. I am currently using an audio
Amp of transistor 2N3055 .It uses two transistors for one channel
.Transformer is of 12-0-12 , 5A .I am not satisfied with the amp
performance.I want some what powerful amp schematic whose transistors
are easily available .I want to drive 12" SUB WOOFER. Hey I hope U are
the person Who can HELP me......Reply .........

There's not really enough information for anything other than a few
general remarks.

Can you give a precise and detailed idea of exactly what you want to do,
like power in watts for example ?

Graham


.

Relevant Pages

  • Re: Griffey changes his mind...derates to 322 watts PEP
    ... Polarized Detachable Power Cord ... Since the transistors you are using are rated for a typical gain of ... doesn't that put your AM "RMS" output about 264 watts? ... Now assuming you have a magical amp that can achieve 55% efficiency ...
    (rec.radio.cb)
  • Re: Onkyo TX-DS 575 / Integra DTR 5 in circuit protection mode
    ... as the the power switch is pressed on, and opens the main power relay). ... The receiver has separate front channel and center/surround channel amp ... I've got to get external voltage to the ... transistors besides the outputs, will likely be faulty. ...
    (sci.electronics.repair)
  • Re: Replacements for 2SA1302/2SC3281
    ... This Pioneer VSX-454 is a Pro-Logic receiver with a 4 channel amp. ... and no insulators are used on the transistors. ... what I found was a few 1/8 W resistors on the L/R amp board ...
    (sci.electronics.repair)
  • Re: ?Suggest UK source for these audio power and driver transistors?
    ... > I've just been reading a few threads about counterfeit transistors. ... > Runs fine with transistors from the other channel. ... > need to adjust the bias, ... transistors, after the amp has been left to idle for 10 mins, then assume ...
    (sci.electronics.repair)
  • Re: Replacements for 2SA1302/2SC3281
    ... > This Pioneer VSX-454 is a Pro-Logic receiver with a 4 channel amp. ... > subbed with Matsushita transistors, ... > flameproof resistors on the L/R amp board had been replaced by cutting ...
    (sci.electronics.repair)