Re: "Stretching" an inductor

On Tue, 03 Oct 2006 14:20:55 -0700, Don Bowey <dbowey@xxxxxxxxxxx>
wrote:

On 10/3/06 9:40 AM, in article
1159893626.467590.75140@xxxxxxxxxxxxxxxxxxxxxxxxxxxx, "Tom Bruhns"
<k7itm@xxxxxxx> wrote:

You wrote, ". . . but I've never found a way of doing anything useful
with this circuit."

If as you wrote in the paragraph after that, you put it in series with
a resistor, you get a circuit that behaves much like a series resonant
circuit. Not only does it go through a phase inversion, but it goes
through zero resistance. Similarly if you put it in parallel with a
resistor, you get something that behaves much like a parallel resonant
circuit: where the gyrator negative resistance equals the parallel
positive resistance, the net resistance goes to infinity. If you think
of C-R-L circuits (or better, 1/sC, R, sL) as having components that
contribute in quadrature, with 90 degrees going from C to R and R to L,
you see that you can have the same effect with three components that
behave as R, sL and s^2Gyrator; you've just multiplied everything by s.
Or you can have a {1/s^2Gyrator, 1/sC, R} set. And you can expand
your filtering horizons by having a set {1/s^2Gyrator, 1/sC, R, sL,
s^2Gyrator} . . . that lets you implement higher order filters in
simpler topologies (if only the gyrator were a simple passive two-lead
part!)

Gyrators don't seem to be used very often, but I have seen them used to
(presumably) keep the op amp out of the direct signal path, in an
attempt to have it contribute less distortion in the passband.

Cheers,
Tom


TuT wrote:
"John Popelish" <jpopelish@xxxxxxxx> wrote in message
news:3-GdnQx1MP5UUrzYnZ2dnUVZ_r-dnZ2d@xxxxxxxxxxxxxxx
Joel Kolstad wrote:
Does anyone know of a simple network that has, say, more than twice the
reactance at 2*f0 as it does at f0? Essentially I'm after a reactance of
2*pi*f*(something super-linear).

You can readily convince yourself that going the other way is no
problem... if you put a small capacitor in series with an inductor, the
slope of the reactance is lowered (since the capacitor's reactance is
dropping with frequency), hence making the reactance at 2*f0 less than
twice what the circuit has at f0.

There may be some version of a generalized impedance converter that
produces a resistive impedance proportional to frequency squared. I have
seen some that produce a negative resistance inversely proportional to
frequency squared, i.e. -1/D*w^2, where D is a constant based on resistor
and capacitor values in the circuit.

That's an FDNR, (Frequency Dependant Negative Resistor), and can be realised
with the basic four-op-amp gyrator circuit using two capacitors and three
resistors. You can get a negative resistance that either increases or
decreases as the square of the frequency, depending where you put the
capacitors, but I've never found a way of doing anything useful with this
circuit.

You can make a frequency dependant voltage divider with an FNDR and a
resistor, but the circuit goes through a phase inversion, the point of
inflection being at the frequency where -R = R

--
T

If it's not broken, don't fix it.


Check out the Sept 14 EDN Magazine, "design ideas" Brick-wall lowpass audio
filter for a practical circuit which uses three gyrators.

I don't care much for EDN, but occasionally a contributor sends them
something really good. This is one.

Don

Cute. But my favorite filter book, Herrero & Willoner, has techniques
where you simply enter pass and stop bands and go directly to Laplace,
thence to active filter, gyrator or otherwise.

...Jim Thompson
--
| James E.Thompson, P.E. | mens |
| Analog Innovations, Inc. | et |
| Analog/Mixed-Signal ASIC's and Discrete Systems | manus |
| Phoenix, Arizona Voice:(480)460-2350 | |
| E-mail Address at Website Fax:(480)460-2142 | Brass Rat |
| http://www.analog-innovations.com | 1962 |

I love to cook with wine. Sometimes I even put it in the food.
.

Relevant Pages

  • Re: Loudspeaker Design Cookbook Volume 1 Formula Assistance
    ... The formula was to calculate a resistance value to smooth ... The circuit you drew and your memory are both faulty. ... the "impedance of Lx at the tweeter's Fs" is ... Assuming the driver resistance and inductance were ...
    (rec.audio.tech)
  • Re: "Stretching" an inductor
    ... you get a circuit that behaves much like a series resonant ... where the gyrator negative resistance equals the parallel ... simpler topologies (if only the gyrator were a simple passive two-lead ... reactance at 2*f0 as it does at f0? ...
    (sci.electronics.design)
  • Re: Ohms Laws
    ... defines Ohm's law. ... potential difference between any two points of a circuit is ... proportional to the resistance between them. ... resistance will not double the voltage across it. ...
    (alt.usage.english)
  • Re: eliminating CMRR problems -- was, 3 dB bandwidth
    ... > been using all NMOS strings, in a totem-pole push-pull circuit. ... what PMOS parts are you using and what is their voltage ... The resistance is across the supply voltage of 1KV, ... The overall bandwidth is limited by the op amp. ...
    (sci.electronics.design)
  • Re: "Stretching" an inductor
    ... you get a circuit that behaves much like a series resonant ... where the gyrator negative resistance equals the parallel ... reactance at 2*f0 as it does at f0? ... and capacitor values in the circuit. ...
    (sci.electronics.design)
Quantcast